This was a mammoth job..and took quite a while whilst I was in hospital quite a bit this first half of the year. Anyway, it’s finished. I’m really chuffed with this little gun. I intend to fire it soon. Given the very poor state it was in it’s really come good. Lovely rare little...
Always a nervous affair dropping metal heated to 723 degrees C into freezing water. Anyway, here is the Clarke parts re-coloured. Thanks to Doug for the mix from Brownells in the US and his advice on the ration. Hammers could be better but I’m pretty happy with the rest of it.
Hi folks, well after my amazement that these got through proof (I have the stamp marks to prove it:) ), it was down to blacking. I’ve just completed the job and they’ve come out OK. Photos below. Now onto the woodwork and the action…but not until after my surgery which is now planned for...
I had completely written off this little gun. The barrels were dreadfully pitted and I thought at best it would be a sleeve job. However, wonders have been worked. It’s been re-honed, tightened up, flown through proof (and it flew through!) and cleaned up, the ribs have been re-laid and here we are. You...
I’ve had to take quite a bit of wood back. I think it’s now sanded enough for my checkerer to restore to at least something close to original. Going to start finishing the wood later. Pictures here;
I bought this little gun for £100. The barrels were very close to being out of proof and the insides looked like someone had dumped water in them and shove a cork in either end for 30 years. It was in very poor condition. With this in mind I gave the stock to a...
